Technical Analysis Of Waterproof Spraying Machine

In the process technology of the waterproof spraying machine, in addition to the adjustment of different parameters of the equipment according to the different coating products, it is also necessary to make correct operations for the treatment of some coating effects during the spraying process. In order to let our product surface achieve the expected quality effect.

High-temperature curing actually means that after the powder coating in the waterproof spraying machine is heated at a high temperature, the coating can be melted, leveled and cured during the spraying process. Among them, the high-temperature heating temperature of the coating must be a predetermined temperature; at the same time, these coatings should be kept warm for a period of time after heating at a high temperature. Only in this way can the surface of the product achieve the desired coating effect.

For the specific method of high-temperature curing treatment of the coating, in fact, the coating is evenly sprayed on the surface of the product with a waterproof sprayer, and then the product is pushed into the curing oven to heat up to a predetermined temperature (usually 180 After 5 degrees), the time required for heat preservation should also be controlled at about 15 minutes. The product can then be taken out of the curing oven and wait for the product to cool down.

Decorative treatment. When the product is sprayed with paint, it needs to be decorated, which requires an electrostatic sprayer to operate. Because compared with traditional spraying technology, electrostatic spraying technology can make the appearance of the product reach a special appearance effect (including wood grain, pattern, bright effect, etc.).

Waterproof sprayer technology is a new type of technology that will inevitably appear in the highly developed process of this era. By introducing the above two spraying technology, it is believed that the construction staff can better operate the spraying equipment.