Basic Operation Of Airless Spraying Machine

　　1. After the installation of each part of the machine, tighten each living interface with the appropriate alarm hand. Note that the connection between the spray gun and the high pressure pipe must be connected with two plate hands. Then put the suction tube (thick) and return line (thin, is it used for air) put the feed bucket, must pay attention to the location of the backflow preventer switch before startup, must be return state, import machines generally backflow valve switch (a long black knob, new machine can rotate 90 degrees) across the (level) is a state of spraying, vertical (vertical) is flowing state, That is to exclude the air in the machine pump

　　2, start the machine, wait until there is material discharged from the return pipe to close the return valve (to the horizontal state).

　　3. Button the gun and press, release the press when the material comes out from the spray gun, and see where the pressure gauge is. Generally, the new machine is not too high (2500PSI or 170Bai) as long as it can be normal atomization paint, the normal construction can be done. After USING THE CLEANING MACHINE, change the PAINT to clean water and follow the above steps until the water comes out.